Adaptation for ETAS measuring technique

In technical development and especially in the automotive sector, it is almost part of everyday life that there are challenges with the cabling of the sensor technology during the preparation or at the latest during the execution of the planned measurements. This is also the case in the application areas of ETAS measurement technology, for example when measuring and calibrating control unit variables and parameters.

A typical example is carrying out measurements on pre-equipped vehicles in which all cables have already been laid. If only one component in the measurement chain "ETK control unit - interface cable - module (e.g. ES59x or ES89x)" is not compatible, the measurements must be realised by means of adaptation.

SAB BRÖCKSKES has e.g. ETK-FETK interface cables and ETK-FETK adapter cables in its programme especially for this area. Further service aspects that we would like to offer you in addition are individual cable lengths, small quantity production, individual labelling and direct on-site support.

Product overview – Adaptation for ETAS measuring technique

ETK - FETK adapter
with Lemo female connector 4-pole and Lemo male connector 10-pin
ETK - FETK - ETK adapter
with Lemo male connector 10-pin and Lemo male connector 4-pin
FETK - ETK adapter
with Lemo female connector 10-pole and Lemo male connector 4-pin
ETK interface cable
with Lemo male connector 4-pin at both sides
ETK extension
with Lemo male connector 4-pin and Lemo female connector 4-pole
FETK interface cable
with Lemo female connector 10-pole and Lemo male connector 4-pin
FETK extension
with Lemo female connector 10-pole and Lemo male connector 10-pin
Questions about our products?

Customized cable assembly according to your wishes.

Family business for construction and production since 1947

Please send us your inquiry
+49 (0)2162 898-0
Monday to Thursday, 7.30–16.30
Friday, 07.30–15.00