Assembly instructions for the installation of the cable in PIT-Systems

1. Planning of cable route

Start by planning the exact route of the cable. This is crucial for the optimum function and longevity of the installation.

2. Check the specification

Check whether the specification of the cable matches your desired application.

3. Laying out the cable

Lay the cable in a straight line on the floor. It is best to use a cable dispenser to make handling easier.
Make sure that the cable is not twisted.

4. Mounting the plug

Fit the plug at the end of the cable if it is not already attached.

5. Examination of the chamber

Before inserting the cable into the PIT system, check the chamber for damage and sharp-edged components

6. Introducing the cable

Insert the unassembled end of the cable into the PIT system without forcing or twisting it.

7. Condition of guide rollers

Ensure that the guide rollers are in good condition and can be moved easily.

8. Inserting the cable

Before connecting the cable, make sure that the cable is inserted as shown in the schematic diagram.

With the GP 400 SF cable, the cable must be inserted anti-clockwise due to the direction of lay. This is important in order to be able to attach the cable clamps in the correct position.

9. Fitting the cable clamps

When attaching the cable clamps, make sure that the cable is fastened without constraint or twisting.

10. Connection to switch box

Connect the cable to the switch box.

11. Final check

After connecting the cable, pull it out once along its entire length and reinsert it to ensure that everything is installed correctly.After connecting the cable, pull it out once along its entire length and reinsert it to ensure that everything is installed correctly.

schematic diagram

The cable is pulled out of the PIT system in clock direction. The cable is turned up!

The cable is inserted against clock direction without twisting.

Maintenance notes

To ensure the longevity of the cable, maintenance is required at least once a month, depending on use. The cable should be fully laid out and the following steps carried out:

turn back any axial twists in the cable
visually check the cable for damage
check roller packs for free movement
check the cable clamps

Highly flexible cables according to your special requirements