>> Individual configuration of reeling connection cables with connectors <<
Your cable combination is not yet shown in our catalogue 400Hz and 28V DC? No problem! Using the following sample configuration, you can easily configure your individual combination of cable and the required connectors yourself. We will be happy to advise you. Just contact us directly.
Note
If you assemble your own cables, please ensure that the cables are unrolled at least 12 hours before assembly.
This serves to prevent possible stresses and increase service life.
Cable on drum
| ☐ GP 400 TF DR | 3 x 70,0 mm² + 3 x 12,0 mm² + 6 x 4 x 1,0 mm² |
| ☐ GP 400 SF DR | 7 x 35,0 mm² + 6 x 4 x 1,0 mm² |
Cable length
_________________________ m
Connection cable
| ☐ GP 400 QF | 4 x (50,0 mm² + 4 x 1,0 mm²) |
| ☐ GP 400 QF | 4 x (70,0 mm² + 4 x 1,0 mm²) |
Cable length
_________________________ m
Complete cable length
_________________________ m
Side 2
☐ wire end sleeves _________________________
☐ pin terminals _________________________
☐ ring cable lugs _________________________
Further accessories
| ☐ with 90% Switch | ☐ PIN E | ☐ PIN F | ☐ PIN E+F |
| ☐ push buttons | ☐ red | ☐ green | ☐ black |
| ☐ LED | ☐ red | ☐ green | ☐ yellow |
| ☐ thermocouple | ☐ PT100 | ☐ PTC120 | ☐ PTC100 |
| ☐ with strain relief | _________________________ mm behind connector end |
Note
Please send us an existing occupancy plan or let us know the desired PIN assignment.
